Canned Salsa Recipe

Objective:

Document best Canned Salsa Recipe

Conclusion:

See below. This came out great when we made it in 2012.

source

http://low-cholesterol.food.com/recipe/canned-bottled-salsa-97196

Yield: 12 pints or 6 quarts

Ingredients

8 quarts plum tomatoes
4 tablespoonspickling salt
6 large onions
2 -3 heads garlic
1 lb jalapeno pepper
6 large mild bell peppers
2 1/2 cups minced cilantro
1/4 cup ground cumin
1 (5 1/2 ounce) can tomato paste
3 tablespoons lime juice (Per 500 ml jar)

Directions

Bring a large pot of water to a boil.
Blanch the tomatoes by dropping them into the boiling water for one minute.
You will need to do them in batches.
Transfer them to a large bowl or sink full of cold water.
Fish them out and peel them.
Chop them coarsely and sprinkle with pickling salt in layers as you go - I try to use about 4 tablespoons.

Put them in a strainer and set in a cool place (but NOT the fridge!) to drain for several hours.

When you are ready to procede, put all the canning jars in a large canner full of water to cover by one inch, and bring to a boil.

Boil for 10 minutes.

If your water is very hard, add a shot of vinegar to the water before it boils (to prevent lime
on bottles).

Meanwhile, peel and chop the onions.

Peel and deseed the peppers, and chop them.

Peel and mince the garlic.

Mix the tomato paste with cupful of the tomatoes until it is lump-free.

Mix all the ingredients except the lime juice in a large kettle or pot.

Bring the salsa to a boil.

Lift the sterilized jars from the boiling water bath and empty them.
(Most should be emptied into the sink, so the boiling water bath doesn't overflow

Add 3 tbsps lime juice to each jar.

Pack the salsa into the jars.

Wipe rims, and seal according to manufacturer's instructions.

(Generally, boil lids and rings for 5 minutes).
Return the bottles to the boiling water bath and process them for 20 minutes.
It may be necessary to do this in two batches; put as many in the canner as you are able to;
when they come out add the next batch of jars to be sterilized while you fill the first set.
Take them out and fill them as the first set of filled jars is being processed.
Remove, allow to cool, and check seals.